Materials
Our reconstituted stone consists of various
materials carefully blended together. The dominant feature
is a crushed naturally occurring limestone. With the
use of colouring pigments we can recreate the effect of Bathstone. Colouring pigments are also used when there is a
need to down the freshness of new stone to achieve a
weathered look on refurbishment projects. |
|
All pieces are individually hand compacted with careful attention to the finish of each
product using techniques which have been employed in the industry
for many years. Although the standard pieces produced are only
intended as a decorative facade being supported by reinforced
concrete or steelwork, individual pieces under the guidance of a
architect or structural engineer can be easily manufactured, to be
load-bearing.
Handling
Reconstituted stone must be handled with great care at all times.
During manufacture air temperature and humidity are carefully
monitored. Once pieces have had time to cure they are laid upon
strips of polystyrene, palletised and then encased in polythene
wrap, prior to goods being transported. Once on site we recommend
that all pallet wrap remains intact to keep units clean and safe
from damage until ready for use.
These products have been used successfully not only in new building
developments but also in the refurbishment of older properties.
Product Tests
In order for us to be able to achieve the very best quality of
product, it is essential that the standard of material reflect this.
Materials are sourced throughout the country to achieve the best
combination for the mix ratio, giving us Strength, Durability and
Appearance.
Test Results
The results of our last test are shown below.
Compressive Strength:
Not less than
35N/mm² at 28 days.
Dry Shrinkage:
0.040%
Initial Surface Absorption:
0.05(ml/m²/sec) after one hour.
|
|
Stone Colour
Below are the two colours that we produce, Bathstone & Portland
Stone.
|